Wooden Tic-Tac-Toe Board

Through this project we used Cad to create a part file and drawing file which we used to then build and make a marble tic-tac-toe board which through this process the goal was to learn and improve our engineering design process

#10 Cap screw

Washer

2x4

Drill Press

Awl

Table saw

Router

Sandpaper

Miter saw

Stain

Clear coat

Marbles

Measure and mark 2x4 board for drill hole, square cut, and lines.

Use measurements from 2x4 board and CAD them up as a part file in solid works

Convert solid works part file into drawing file and print it out

Cut out 2x4 and cut lines on table saw

Use Drill press to drill 9 marble holes on top of board

Measure, Mark, and drill marble storage on end grain

cut thin piece of 2x4 and cut smaller to create door

drill hole in center of door and end grain where marble storage it to attach door

Sand and router door and tic-tac-toe board

Stain tic-tac-toe board and door

Clear coat tic-tac-toe board and door

Screw door onto tic-tac-toe board

Play Tic-Tac-Toe